FREE SHIPPING ON ALL CONTINENTAL U.S. RETAIL WEB ORDERS OVER $75.

EXP94NAW

Water Resistant Windbreaker Anorak Jacket

Color
Black
Graphite
Classic Navy
Forest Camo
Black Camo
Size

Download Sales Sheet

  • Our EXP94NAW Nylon Water Resistant Windbreaker Anorak Jacket has waterproof nylon fabric that screen prints well. It features an adjustable 3 panel hood with fine mesh lining, scuba neck with 1/2 length zip, hidden zipper front pocket with snaps inside front pocket flap, side slit pockets, elastic cuffs, and tightening toggle at waistband.

    The Nylon fabric interior is coated with a 100% waterproof coating...however, we give this jacket a Water Resistant rating because the seams are not glued/taped/waterproofed, which may allow water to eventually enter through the seams when exposed for extended periods of time in a downpour. Get outside and enjoy!

    • 100% nylon 150gm 320 Denier with Interior PU waterproof coating
    • Nylon Outer Shell: Waterproof Coating = Level 3
    • Inner PU Coating: Breathability/Permeability = 5,000
    • Water Pressure Resistance = 10,000 mm
    • DTM neck taping
    • tear away neck label
    • #5 DTM body coil zipper
    • matte metal zipper pull
    • rubber zipper pull tab
    • zipper garage
    • fine mesh hood liner
    • matte nickel metal eyelets
    • 3 panel hood
    • scuba neck
    • round poly drawstring
    • hidden snaps inside front pocket flap
    • side slit pockets
    • tightening toggle at waistband
    • elastic cuffs
  • Please Note:

    Use a nylon or plastisol ink with a catalyst (hardener). Certain Poly Inks can work as well. Ask your ink supplier. Keep in mind a catalyst will shorten the shelf life of the ink leaving left over ink unusable as it will harden.

    Use tight screens with 200+ mesh count to lay down a little less ink than would be used on tees (tees normally use a more open mesh like a 110). Ink tends to sit on top of the surface of this fabric as opposed to pressing into cotton type fabrics. A harder squeegee can help lay down less ink and help keep cleaner design edges.

    Nylon fabric also tends to move more than tees on the printing pallet. Sometimes a jacket clamp is recommended when doing multi-color prints.

    Curing time and temperature will vary by ink types used on nylon fabrics. VERY IMPORTANT to cure your ink at the right temperature without burning or shrinking nylon. Nylon fabrics should usually be cured at temperatures under 320. Flash at low temperatures to keep from burning and/or shrinking fabric. (consult ink supplier and test).

    Washing the printed sample garment(s) after 24+ hours (so hardener has set) is recommended to make sure you have proper curing and ink adhesion.

    *ALWAYS consult your ink supplier for the right ink, cure temperatures, and curing time. Then run your own test sample(s)





Related Items